Spider

The rods attached to the body allow the level regulator to work in narrow spaces and in difficult environments with turbulent waters.

Patented
 
CLEAN WATER
 RAIN WATEr
INDUSTRIAL WATER
WATER CONTAINING CHEMICAL SUBSTANCES

Principle of Operation

Based on the electrical conductivity of the water

Spider is connected to 3 batons: Common as ground - Min as minimuml level - Max as maximul level

The water reaches the weel and the level increases
Spider turns ON the pump when the maximum level baton detects the water
The water level decreases and Spider turns OFF the pump when the minimum level baton doesn’t detect the water anymore

Factory Delay Times

Start

0"

Stop

0"

Setting Delay Times

By means of the supplied magnetic key, the customer is able to adjust the delay time of start and stop according to its own needs of use.

Setting Start Delay Time

  1. Disconnect the plug from the electrical system;
  2. Put the magnetic key close to the arrow stamped on the side of the electronic controller;
  3. Connect the plug to turn on the pump;
  4. Hold the magnetic key in position for how many seconds you wish to delay the starting time (maximum 120 seconds);
  5. Once you got the desired delay time, remove the magnetic key.

Setting Stop Delay Time

  1. Connect the plug to the electrical system;
  2. Wait for the pump shutdown;
  3. Put the magnetic key close to the arrow shown on the side of the electronic regulator and the pump starts;
  4. Hold the magnetic key in posion for the seconds necessary to delay the shutdown (maximum 120 seconds);
  5. Once reached the desired time, remove the magnetic key.

Cables

Neoprene cables IMQ certified

Available Lenghts

0,70 - 5 - 10 m

Available Types

H07 RN-F 4G1 Ø 9,7mm
(only 1 function) - SPST - N.O.

Power Supply

Made in Italy Motherboards

Types

230Vac 50/60Hz 10A
12/24 Vdc - Vac 10A

Accessories

Brackets and Supports

Polypropilene Bracket*

tube or wall fixing

Stainless Steel Bracket*

AISI 304

Flanged Support*

2"

Schuko Piggyback Plug*

The schuko piggyback plug provided with the float switch allows to connect a pump without a switch directly to an electrical socket as to controll the start and stop function.

*Available On Request