Snake
In combination with Probes or Taurus (sold separately) it allows the installation of the control body at a very long distances from the workstations.
PATENTED PRODUCT
Applications:
CLEAN WATER
RAIN WATER
INDUSTRIAL WATER
WATER CONTAINING CHEMICAL SUBSTANCESDownload:
Principle of Operation
Based on the electrical conductivity of the water
Snake with Level Probes
1. The tank fills
2. Snake turns ON the pump when the maximum level probe detects the water
3. The tank drains
4. The water level decreases and Snake turns OFF the pump when the minimum level probe doesn’t detect the water anymore
2. Snake turns ON the pump when the maximum level probe detects the water
3. The tank drains
4. The water level decreases and Snake turns OFF the pump when the minimum level probe doesn’t detect the water anymore
Snake with Taurus
1. The tank fills
2. High level starts the pump
3. The tank drains
4. Low level stops the pump
2. High level starts the pump
3. The tank drains
4. Low level stops the pump
Setting Delay Times
By means of the supplied magnetic key, the customer is able to adjust the delay time of start and stop according to its own needs of use.
Setting Start Delay Time
- Disconnect the plug from the electrical system;
- Put the magnetic key close to the arrow stamped on the side of the electronic controller;
- Connect the plug to turn on the pump;
- Hold the magnetic key in position for how many seconds you wish to delay the starting time (maximum 120 seconds);
- Once you got the desired delay time, remove the magnetic key.
Setting Stop Delay Time
- Connect the plug to the electrical system;
- Wait for the pump shutdown;
- Put the magnetic key close to the arrow shown on the side of the electronic regulator and the pump starts;
- Hold the magnetic key in posion for the seconds necessary to delay the shutdown (maximum 120 seconds);
- Once reached the desired time, remove the magnetic key.
Available Electrical connectons
Standard Applications
Technical Datas
Casing: Polypropylene
Grommet: TPV
International Protection: IP68
MODEL | NEOPRENE CABLE | LENGHT (m) | POWER SUPPLY | TEMPERATURE | DEPTH | NOTE |
|---|---|---|---|---|---|---|
SNAKE (230v) | H07 4G1 SPST-NO | 0,70 / 5 / 10 | 230Vac 50/60Hz 5A | max.+40°C (+104°F) | max.10m (32,8ft) | for pumps till 1,5HP |
SNAKE (12V) | H07 4G1 SPST-NO | 0,70 / 5 / 10 | 12/24Vac/dc | max.+40°C (+104°F) | max.10m (32,8ft) | for pumps till 1,5HP |
Accessories
Brackets and Supports
(* May not be included)
Polipropylene Bracket
tube or wall fixing
Stainless steel bracket *
aisi 304
Supports
tank fixing
Flanged*
2"
Threaded*
2" Gas
Schuko Piggyback Plug*
The schuko piggyback plug provided with the float switch allows to connect a pump without a switch directly to an electrical socket as to controll the start and stop function.
